How to Get Started using Plain Proxies Residential Proxies

A Guide on how to set up PlainProxies Residential IPv6 Proxies

Generating your Proxy

Once successfully purchased your first plan, it's time to generate the proxy for your needs.

Using the proxy generator seen below you can select the following options:

Proxy Geolocation (Country, City)

Proxy Protocol (Http/s, Socks5)

Proxy Type (Rotating, Sticky)

Proxy Format (IP:Port:User:Pass, User:Pass@IP:Port)



Selecting Proxy Geolocation



Selecting the right geolocation can be crucial when scraping certain targets. Some websites enforce a geoblocking policy, only allowing IPs from certain geographical locations to access their content.

Choosing a geolocation close to your operating machine can also speed up your scraping operation, lowering ping to connect to the proxy.


To view a list of geolocations that are available for PlainProxies IPv6 Residential Proxies click here.

Selecting Proxy Protocol



Selecting the right proxy protocol is usually simple. If you want to scrape web content via http requests, then you need to select Http/s as your desired proxy protocol.

Socks5 is only needed in cases where you want to use a lower layer of network communication.

“SOCKS is an Internet protocol that exchanges network packets between a client and server through a proxy server. [...] Practically, a SOCKS server proxies TCP connections to an arbitrary IP address, and provides a means for UDP packets to be forwarded.” ( Socks5 - Wikipedia)

Selecting Proxy Type



Unlike a normal static proxy, a rotating proxy is rotating it's outgoing IP on every request.

The number one reason to use a rotating setup is to avoid rate limiting.

PlainProxies static sessions can be customized to perfectly fit your scraping needs, keeping the same IP for a certain amount of time.



As seen above when selecting Sticky Proxy Type there will be additional options popping up.

Session Lifetime

Session Timespan

Proxy Amount

Session Lifetime and Session Timespan combined will define the time that the proxy generated will keep the same outgoing IP.

Additionally for static sessions you are able to generate a custom amount of proxies. All of these sessions will correspond to an outgoing IP. Once the lifetime (e.g. 1 minute) is over, the outgoing IP will change.

Updated on: 20/02/2025

Was this article helpful?

Share your feedback

Cancel

Thank you!